stevewarner1957
Gold Member
It will be ok! 
Hand throttle for 2016 RTV X1140? I can't find one....Is it a unicorn?
- Thread starter raptorterry
- Start date
OP
raptorterry
Silver Member
I thought I was rockin and rollin after my crinkle paint turned out so good.
It could always be worse.
OP
raptorterry
Silver Member
My local Kubota service guy has been a big help with my "little" 40 minute project. He found a tech that was familiar with the hand throttle. The tech said my kit should have come with a double fork to hold the "new" throttle cable.
So now I'm in search of the illusive Kubota double fork bracket.
So now I'm in search of the illusive Kubota double fork bracket.
stevewarner1957
Gold Member
My local Kubota service guy has been a big help with my "little" 40 minute project. He found a tech that was familiar with the hand throttle. The tech said my kit should have come with a double fork to hold the "new" throttle cable.
So now I'm in search of the illusive Kubota double fork bracket.
If you didn’t have bad luck you wouldn’t have any at all!
OP
raptorterry
Silver Member
Hee Haw! I loved that show! I bet the out takes were hilarious!If you didn’t have bad luck you wouldn’t have any at all!
I sent an email to Kubota customer service. I hope we can figure this out.
BTW, the guy at Messicks is being very helpful.
stevewarner1957
Gold Member
Good. It sounds like your kit was incomplete. I would think they would just reorder another one
OP
raptorterry
Silver Member
You would think that but l think Kubota didn't create a complete kit.
Here's the V4497 parts list.
No bracket listed.
It's cra cra but I'll get it figured out eventually.
Here's the V4497 parts list.
No bracket listed.
It's cra cra but I'll get it figured out eventually.
stevewarner1957
Gold Member
OP
raptorterry
Silver Member
Hmmm, l wonder if this kit wasn't ready for prime time?
stevewarner1957
Gold Member
It’s for your 1140? Other than the cable length I can’t see why it would be different.