Need help finding thread

[Fishguy]

Hey Everyone,
I've been doing a lot of searching trying to relocate a post I ran across some time back. Maybe one of you will know it and point it out to me.

It's about a guy that modified his middlebuster blade so that it would cut deeper and leave a flat bottom in the ditch. If I'm not mistaken, he cut a 12-18 inch or deeper trench/ditch. The photos he posted were awesome.

Again, I tried to search but just came up with way too many posts to scan thru.

Any ideas?

Steve

 

[Rara Avis]

This one?
http://www.tractorbynet.com/forums/attachments/116612-how-deep-will-middle-buster.html

 

[Fishguy]

No, that's not it.
If I remember right, the fella was using it to dig out for a foundation. Guess that's why one should mark a favorite post!

Thanks though,
Steve

 

[Fishguy]

I finally found the post.

http://www.tractorbynet.com/forums/projects/95254-40x40x16-steel-tractor-shop.html?highlight=trench

Looking at the pics and reading the post, I can't quite get a grasp of the making of it. Guess I'll try to get in touch with the guy.

Thanks again,
Steve