Hmm, Mine does not have this rubber insert either and its a 2008. I've lost 4 bolts that tensions the rops. They always tend to rattle loose and out. I need to get some more but this time I'll double up on the nuts to lock them in. I'll look into these rubber pieces.
NEW 2610!
- Thread starter SwampKing
- Start date
- Views: 6598
MrSteve
Platinum Member
Just drill a hole at the start of the threads of the bolt and insert a cotter pin or a set pin (after bolt is installed)... This way it can only loosen so far before the pin stops it from going any farther and falling out. Or a real easy way... After installing the bolt, just take a center punch and hit the last few threads, that should be all that is needed to stop the bolt from coming out "easily".
OP
SwampKing
Bronze Member
On my old 2310 I used rubber garden hose gaskets on the ROPS bolts to quiet the rattle. It worked pretty good.
