NH 7308 Loader Owners
- Thread starter Spencer
- Start date
- Views: 51584
RuT
Member
Zexel:
I'd like to try the gauge out when you are finished. Send me a PM when you are done with it. I'll get you my address.
Thanks,
Jeff
I'd like to try the gauge out when you are finished. Send me a PM when you are done with it. I'll get you my address.
Thanks,
Jeff
Rip
Platinum Member
Dave,
Sorry to hear about the sheared off adjusting screw, but as long as the lock nut is snug, you probably won't have to adjust it any time in the future and you should be fine. It probably would not be hard or expensive to replace either.
Did anyone else have this happen while adjusting the pressure or is this a first?
Rip
Sorry to hear about the sheared off adjusting screw, but as long as the lock nut is snug, you probably won't have to adjust it any time in the future and you should be fine. It probably would not be hard or expensive to replace either.
Did anyone else have this happen while adjusting the pressure or is this a first?
Rip
davcon
Member
Zexel,
Sent UPS today. Good Luck.
Dave
Sent UPS today. Good Luck.
Dave
Robert_in_NY
Super Member
- Joined
- Aug 1, 2001
- Messages
- 8,552
- Location
- Silver Creek, NY
- Tractor
- Case-IH Farmall 45A, Kubota M8540 Narrow, New Holland TN 65, Bobcat 331, Ford 1920, 1952 John Deere M, Allis Chalmers B, Bombardier Traxter XT, Massey Harris 81RC and a John Deere 3300 combine, Cub Cadet GT1554
I would like to try the gauge when you get done with it Jeff. Send me a PM when you are done and I will get you my address. Take care and thank you Spencer for having this contraption built /forums/images/graemlins/laugh.gif
I just completed using Spencer`s gauge(Thanks Spencer!) to adjust my TC33D. the pressure was 1550 at 2600 RPM set it to 1800. Blue29toy I beleive you are next in line, if not, whoever is send me an PM with your mailing address and I will send the gauge to you.
just a little line to let everyone known, to replace that allen head screw is about 247 dollars. I took my cover off and noticed that mine was missing. The nut and screw had broken off. The paint was nice and clean (black) but, you could tell it had been there at one time. New Holland would not replace under warranty. I have had my tc about 2 1/2 years and have about 200 hours - mowing grass. So please be careful with this allen head bolt
bharley
New member
I'm sure there are some in line before me, but I would like to try the gauge on my 7308 when it is available. Thanks
OP
Spencer
Veteran Member
- Joined
- Jan 2, 2002
- Messages
- 1,267
- Location
- Western Michigan
- Tractor
- NH TC33D w/R4 Tires, Rear Remote, Hydraulic Toplink, 2 Auxiliary Work Lights, 7308 Loader w/Kasco Uni-Hitch (Quick Tach)
Does anybody know where the gauge is now?
