NH T4.90 Heat/AC Problem

   / NH T4.90 Heat/AC Problem #1  

Jackfr

Gold Member
Joined
May 28, 2008
Messages
328
Location
Plymouth, MA
Tractor
NH WorkMaster 33 Ford F5000 NH T 4.90 Ford 2110 JD555B
Has anyone had problems with a 2017 NH T4.90 Heat/AC? We replaced the Heat valve last year because there was no heat and valve was stuck closed. It worked fine until now controlling the amount of heat/AC. Now it is stuck open so full heat and no AC. It's a real PIA to get to the heat valve to replace it again. I've checked all the fuses for the controls all appear to be good. Any suggestions?
 
   / NH T4.90 Heat/AC Problem #2  
You could install a manual water valve, there are many available hand screw type or cable operated.
We used them in trucks as a low cost repair.
 
   / NH T4.90 Heat/AC Problem
  • Thread Starter
#3  
I've been trying to find one but no luck so far. The hose is 14mm ID according to the parts book. Which is a little larger than a 1/2" and smaller than a 5/8".
 
   / NH T4.90 Heat/AC Problem #4  
If you are committed to a manual valve you could disconnect the hose and test fit a 5/8th nipple , if to big than Yeah 1/2 inch(14mm) is a odd size. Guess its a trip to the local hardware to make your own.
Recommend to use brass.
 
Last edited:

Tractor & Equipment Auctions

2007 MACK CV713 WINCH TRUCK (A53843)
2007 MACK CV713...
2018 HINO 338 KNUCKLE BOOM TRUCK (A51406)
2018 HINO 338...
Reel Mower (A55851)
Reel Mower (A55851)
2015 Kenworth T370 Service Truck with Crane, VIN # 2NKHHJ7X3FM425081 (A54865)
2015 Kenworth T370...
CAT 320B Excavator (A54865)
CAT 320B Excavator...
1984 Gleaner A630 Corn Head (Deutz-Allis branded) (A55302)
1984 Gleaner A630...
 
Top