NH T4.90 Heat/AC Problem

   / NH T4.90 Heat/AC Problem #1  

Jackfr

Gold Member
Joined
May 28, 2008
Messages
328
Location
Plymouth, MA
Tractor
NH WorkMaster 33 Ford F5000 NH T 4.90 Ford 2110 JD555B
Has anyone had problems with a 2017 NH T4.90 Heat/AC? We replaced the Heat valve last year because there was no heat and valve was stuck closed. It worked fine until now controlling the amount of heat/AC. Now it is stuck open so full heat and no AC. It's a real PIA to get to the heat valve to replace it again. I've checked all the fuses for the controls all appear to be good. Any suggestions?
 
   / NH T4.90 Heat/AC Problem #2  
You could install a manual water valve, there are many available hand screw type or cable operated.
We used them in trucks as a low cost repair.
 
   / NH T4.90 Heat/AC Problem
  • Thread Starter
#3  
I've been trying to find one but no luck so far. The hose is 14mm ID according to the parts book. Which is a little larger than a 1/2" and smaller than a 5/8".
 
   / NH T4.90 Heat/AC Problem #4  
If you are committed to a manual valve you could disconnect the hose and test fit a 5/8th nipple , if to big than Yeah 1/2 inch(14mm) is a odd size. Guess its a trip to the local hardware to make your own.
Recommend to use brass.
 
Last edited:

Tractor & Equipment Auctions

2019 VOLVO L70H WHEEL LOADER (A52706)
2019 VOLVO L70H...
2001 INTERNATIONAL 4700 4X2 SERVICE TRUCK (A52706)
2001 INTERNATIONAL...
2013 Ford F-550 Ext. Cab 4x4 Auto Crane 6406H 6,400LB Crane Service Truck (A53422)
2013 Ford F-550...
16 T/A  TRASH TRAILER (A55745)
16 T/A TRASH...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
New/Unused AGROTK YC-32G Sawmill (A54865)
New/Unused AGROTK...
 
Top