Rake side delivery rake

[sprintersteve]

I have an old side delivery rake. Last season the tire on the right side (looking at from the rear) went flat and i was not able to inflate because it lost the seal to the rim. I was able to get it off and have a tube put in, still looks great. This season however the other tire is flat, same situation, it has lost the seal to the rim so i can't pump it up.

What is the trick in getting that side off. it has the universal joint on the outside that leads to the clutch box.
please help.

Steve

 

[Texasmark]

How about a drift/roll pin through the wheel axle part of the coupling? Something has to hold the yoke onto the axle shaft. Doesn't help you but on later models there is a spring loaded coupling there and just like undoing a PTO shaft you push the button and pull it off. Clean the grease and dirt off it and look for the hole in the casting then drive it out.

Mark

 

[sprintersteve]

There is a spring loaded pins, just like on any PTO, i did not look for a roll pin to bang, but will, i hope i see one.
Thanks for the help.