Toothbar idea

   / Toothbar idea
  • Thread Starter
#11  
Here is an update on my toothbar plans.

Before welding up RR spikes on a section of cutting edge, I am considering cannibalizing an old sickle bar mower that I dragged out of the woods today. The mower has a MM plate and a 7’ bar. My plan is to cut off a 54” section and bolt it directly to the bottom surface of the existing cutting edge on my Gehl skid loader. I am considering cutting internal threads on the sickle bar and running hex head bolts down from above.

Your comments are appreciated.

I will plan to post a picture when done.
 
   / Toothbar idea #12  
As long as the mower is 'beyond salvation'.. I'd say that's a good idea.. blade guards.

You could also use plow bolts.. or carriage bolts.. plow bolts would / could be flush with some drilling and or filing.

I've sucsesfully installed cariage bolts by drilling a hole that will almost accomodate the square sub head, and then filing it out to fit..

Soundguy
 
   / Toothbar idea #13  
OldJD,
Here's a photo of the toothbar I made for my 72" bucket. I used a piece of 1/2" x 4" cutting edge and some 1" x 1" tempered bar stock with one end cut on 45's for the shanks. The teeth are bolt on skid loader teeth. Total cost of the project was $120, with the biggest expense being the 72" cutting edge @$60 . This bar wasn't used much yet but I made another one exactly like it for my B2150 when I had it and it worked great. If you take notice, this bar is mounted on top of my present bucket cutting edge. This makes the bottom of the teeth approx. 3/4" off the ground surface. I made it this way because I do alot of work on macadam roadways and this way I can put my bucket at a level position and scrape ground off the road with out having the teeth dig in leaving grooves on the roadway. The 2 center bolts on the cutting edge are plow share bolts and are countersunk into the bottom of the bucket cutting edge for a flush fit.

Bill
 

Attachments

  • 630217-tooth bar.JPG
    630217-tooth bar.JPG
    66.8 KB · Views: 510

Tractor & Equipment Auctions

2014 CATERPILLAR CT660S SBA 6X4 DUMP TRUCK (A51406)
2014 CATERPILLAR...
80in HD Tooth Bucket with Side Cutters ONE PER LOT (A51039)
80in HD Tooth...
S Houle WD-10B Pull-Behind Hydraulic Turf Aerator Tractor Attachment (A49461)
S Houle WD-10B...
Komatsu PC490LC-11 Hydraulic Excavator (A49346)
Komatsu PC490LC-11...
2020 New Holland 105 Workmaster MFWD Compact Tractor with 632TL Front Loader - Poultry Special (A51039)
2020 New Holland...
(INOPERABLE) MAROOKA (A50854)
(INOPERABLE)...
 
Top