3rd Function install Summary on DK40SE HST

[murphy1244]

Nice! Here's a bracket the dealer fabbed for my QDsView attachment 413567

You might collect water in there keep it covered. Very nice job.

 

[kspring61]

Nice! Here's a bracket the dealer fabbed for my QDsView attachment 413567

Thanks for the picture
Just talking with a buddy at work that has a machine shop at his home. We were looking at doing the same thing, but I will most likely have the bracket turned 90 degrees so the QD's are facing toward the side of the tractor. I have plenty of slack in the Grapple lines to do this.

 

[Msamt]

Yep, good idea, turning them. I havent had any issue keeping them plugged with either the QDs or the dust boots though, but good dealer, didnt even make me have to think about them.

 

[varmint]

Surplus center sells these nifty little mounts for hoses... they work well.
1/2 IN TWO WIRE DUAL HYDRAULIC HOSE CLAMP

 

[N2DFire]

Pretty good looking set-up.

I'm working on building out a 3rd function set-up myself. Not so much for doing it "cheaper" (although I'm thinking we'll save $150-$200 in the end) as much as doing it exactly like I want it (just picky like that).

I haven't really wanted to endure the down time to pull one of the "Banjo Bolts" in the power beyond line to get it's measurements so I was curious if you had / knew the specifics on the two adapters?

Thanks

 

[Brozum01]

Do you have a link to purchase this kit?

 

[Brozum01]

What hydraulic flow rate does the 3rd function flow?

 

[N2DFire]

Do you have a link to purchase this kit?

The kit from EA is made by W.R. Long and can be found here:
Everything Attachments 3rd function kit

I wasn't a fan of the actual control grip so I built my own 3rd function using a JD grip.

Attachments

• 3rd function build - Revised.pdf

  2.5 MB · Views: 269