Recent content by diz

  1. D

    2305 diverter valve slop

    I've had a diverter valve hooked up on my 2305 since fall. When I use it now, in mower independent lift position, the deck goes up and down but the bucket curls slightly as well. I don't remember this from last fall, maybe I hooked something up wrong this spring, or maybe that valve is...
  2. D

    Curtis Cab Heat Hose Wear

    Howdy! I put a cab on my 2305 this winter, ran the heater hoses according to the directions (at least I think so). There are two points I can see where the hoses are rubbing and have already worn flat spots into the hoses. One is at the top of the apex as the hose goes over the air...
  3. D

    2305 Curtis Cab Heater Install

    So I finally received my heater, and ran the hoses tonight. Stopping leaks at the T fitting installed on the thermostat where the temp sender sits was a pain, and I'm not 100% sure I'm done tightening that vertical piece. Should there be teflon tape on that or something? Real question...
  4. D

    2305 Curtis Cab Install

    The pics I wish I had when deciding to purchase, and then installing, a soft side cab on my 2305. Note that I'm not saying I installed everything correctly, and I'm not quite done. Hope they help others.
  5. D

    IMatch and PHD

    I have a 2305 w/ an imatch, and a shiny new leinbach post hole digger. I searched a bit and see people agreeing on two things: 1. No PHD will work w/ imatch. 2. Pat's easy change will work w/ PHDs. Went to Pat's site, watched the videos, and it looks like it would work w/ a PHD, but that...
  6. D

    2305 Temperature Gauge

    Hi, I could swear at some point I found some posts here that discussed tapping into a diagnostic port (like the OBD in a car) and getting engine temp data, but I can't find anything about it now. Anyone know anything about that? If I can get the data, I can come up w/ something to display...
  7. D

    2305 Diverter Valve Kit

    I have the independent lift on my 2305, and am lazy so I'm thinking of that diverter valve kit. Local dealer wants $353 for the kit, plus $90 to pick it up, install, and drop off. Has anyone installed this kit themselves? How tough is it? Thanks!
  8. D

    2000 series buying

    The time has come, wife approved the purchase. I'm seeking advice. I've trolled these boards for about a year now, so have read a lot of posts. I'll stick to things I haven't seen asked/answered already. Background: We have almost an acre in Rochester, NY. Most of that is grass or...
Top