Search results

Does anyone have a K9 with the factory winch mount plate? I can't figure out how to bolt on the fairlead.

Kioti CK30HST with the KB2375 backhoe. Nimco 1S-5709 valve body Owned since new, 2005. I've had a small leak for several years that turned into a steady drip drip drip, almost a stream. Removed the valve body & took it to a hydraulic shop for a rebuild. Reinstalled and immediately noticed the...

CK30HST with the KB2375 backhoe. Nimco 1S-5709 valve body Owned since new, 2005. I've had a small leak for several years that turned into a steady drip drip drip, almost a stream. Removed the valve body & took it to a hydraulic shop for a rebuild. Reinstalled and immediately noticed the...

I've had a leak at the control valves for some time now but recently it has accelerated. I assume there are seals & maybe O rings that are replaceable. Is there a factory manual available? Does anybody have a copy? An exploded diagram would be helpful. Are there any special tools required...

This is probably a dumb question but it would sure be handy every time I hooked a rock with the post hole digger.

I suspect my clutch is bad but not sure. I had an ignition switch fail while mowing and then later the interlock module failed when I switched on the pto. Can anyone tell me the specs for one? The factory manual shows the coil should have .3 to .5 Ohms resistance. Mine has 3 Ohms. That would...

If so, I'd like to hear about it. So far on mine it runs & I have lights. Working on the pto now. It's a 931014, 10hp gear drive. Maybe 1979 vintage.

every time I take the backhoe on or off I have to lay on my back & reach up with a little wrench & open or close this thing. Is it possible to put a handle on it to make it a little easier?

It seems like I read about this but now can't find it. The throttle does not move smoothly away from idle. Fact is, it sticks and requires force. as a consequence it jumps from idle to 2000 or higher. Not at all smooth. Is there some adjustment to the tension ?

Does anybody have either of these 2 factory options on their CK30 HST ?