Rear Hydraulics

[DMF]

Here is a shot of the front lines showing the QC's. I still need to make some brackets for the connectors. I am having issues with the fittings...They are Parker 3000 PSI version; FF-371-6FP (female) and FF-372-6FP (male) which are supposed to be very high quality. My problem is I have a real hard time (read impossible) to reconnect my dump trailer. It's always on the tractor end (not the trailer) that gives me a problem and only one side? /forums/images/graemlins/confused.gif

Very frustrating! I had to unscrew the connector and bleed some fluid to reconnect; not exactly a quick connect set-up! I must be doing something wrong?

 

[DMF]

Dump trailer in action!

 

[JerryG]

If the pressure is on the trailer side, make sure that you "turn the tractor off" and work the valves before you disconnect the hoses.

If the pressure is on the tractor side, make sure that you "turn the tractor off" and work the valves before trying to connect the hoses.

 

[DMF]

</font><font color="blue" class="small">( If the pressure is on the trailer side, make sure that you "turn the tractor off" and work the valves before you disconnect the hoses.

If the pressure is on the tractor side, make sure that you "turn the tractor off" and work the valves before trying to connect the hoses. )</font>

It appears that it is always on the tractor side. My nephew suggested this to me as well and it appeared to work when he tried it, yet I couldn't get it to repeatably work. It's strange because when I loosen the connector on the tractor side only a very small amount of fluid leaks out and it is certainly not under any pressure...? /forums/images/graemlins/confused.gif

 

[jeepcj7]

Not sure what valves you have, but if you have the factory valves from Iseki that use levelrs thru the slots on the RH fender, there is a small screw you need to turn to set the valve to single acting. I am assuming of course that your dump waon has a single acting cylinder with only one line going to the cylinder.

 

[DMF]

No, I added a 3-spool valve from Prince (see one of my previous posts with the attached photos) The cylinder is a double acting with two lines...

I sent a request to Parker to see if they had any suggestions. No response yet...

 

[MadReferee]

Your Prince valve's mounting looks a lot like mine.

I have to relieve the pressure on the lines by stopping the tractor and moving the spool lever in both directions before I disconnect my dump trailer. I also have to do it for the snowblower.

 

[DMF]

</font><font color="blue" class="small">( Your Prince valve's mounting looks a lot like mine.)</font>

A lot? I guess, it's quite alike!

</font><font color="blue" class="small">( I have to relieve the pressure on the lines by stopping the tractor and moving the spool lever in both directions before I disconnect my dump trailer. I also have to do it for the snowblower. )</font>

MAD - I tried this as well (see my post above) but it wasn't repeatable, in fact it didn't work more times than it did work...
Any ideas? /forums/images/graemlins/confused.gif

 

[DMF]

More progress! I was at my BIL's machine shop last night until 11:00 working on some wagon repairs (posted in Build it yourself) and some brackets to mount the quick connect couplers to my tractor. (right now they are just wire-tied)

This photo shows them roughed out (my blueprint is in the back)

 

[DMF]

Here are the finished brackets. Two are for the rear and one is for the front (the one without the mounting holes as I haven't figured that out yet). The rear brackets will get paint and hopefully be mounted this weekend, yippee!