In researching hydraulic fluid levels for this tractor am I correct in that I check 2 different places. 1). The transmission level for transmission and 3 point at plug next to clutch pedal. 2)...
Can anyone tell me what this hole in the housing is there for? It’s dripping hydraulic fluid like a faucet that needs a new gasket or money going out the window like Bidenomics. 😵💫 6 volt VW...
Hello everyone,
So a good mate of mines getting rid of his Kubota, the story is that he was using it, it started to become smokey. He then drove it for Abit, before he turned it off and left it...
Hello, I have a Kubota L295dt 4x4.
Currently running 7-16 front tires and 12.4x24 rear tires. Wondering if I can change front tires to 8.3-16.
I've come up with 0.656 ratio for my current setup...
I recently bought a 1983 kubota l295dt. It came with power steering well it was leaking bad. I removed it and put the steering arm back in place (the dealership still had it). I filled it back up...
No FEL, thinking about including FORD 5' snowblower. Unknown hours since meter does not work. Second owner. Full sets of (old ) ag tires as well as (newer (2-300hours ) turf tires. Tractor is...
Yep, your old cutting edge is worn out and you are about to get into the bucket itself. You don't have to spend lots of money here if you have a little 110v wire welder. Get one. You won't...
Sooner or later, the four bolts that hold the steering column on the transmission are going to get loose. Tranny juice will splash out from under the column, run down the side of the critter and...
I'm looking at up sizing from my little 18HP Kubota with turf tires, to something that can actually pull and has a loader.
I'm on 20 acres, need to mow some of it occasionally, mainly wanting a...
Hi Guys,
My tractor came with a hoe on the back instead of the 3pt. Now that the hoe is removed I been trying to get the right 3 pt configuration. I have the right check chains, but have...
Brand new to your forum. My old Ford is about to die and I'm interested in a Kubota around the corner from me that looks like it just came out of the crate.
It's beautiful. He's asking $11,900...
Engine is overheating. Replaced head (new) 100 hrs ago, new water pump last year, new thermostat, temp sender, radiator has been boiled out and rodded and is like new. Replaced soft plug on block...
I have a gray 2202DT and started having problems. Hard to start and then wouldnt start at all. I replaced the ignition and battery. Then it just cranks. I started to replace the gloplugs and had...
I was replacing the transmission fluid and dropped the spring and metal screen filter as I was removing it. What order and direction do they go? Top of filter screen first, which would put the...
Hi,
New to this forum and first return to tractors since my childhood with Fords from the 80's.
I've purchased an old 5 acre old farm and want a tractor to do the winter plowing and help me...
Can anyone help me with hyd troubles on my L295DT? Any info out there for the backyard mechanics like me to troubleshoot hyd troubles on this tractor and how to plumb this tractor for a loader...
I have a L295DT with a 1200 HD loader that is now plumbed from the PTO pump along with the backhoe. I need to change the lines so I can run the loader off of the tractor pump so the loader can be...
How and where do I check to see if the hyd. pump is working right. Also where could I tap in for attachments. My first Kubota and not very familiar. Thanks for your help in advance.
I recently bought a L295 kubota with a loader and backhoe, both the loader and backhoe hydraulics are run by a PTO driven hyd. pump. It does not have a live pto, so everytime I depress the clutch...
I may have a chance to buy a 1975 Kubota L295DT. the clock says 2300 hours, I think it is right, the tin is rusty and dented, it appears to have some small leaks, the tires are about 50%, and it...
I'm trying to establish the present value of an old 1988 Kubota L295 in "rough" though operational shape. This is a farm rig that has always been stored outdoors. It is operational though often...
Hello everyone,
I am posting for my wonderful 80 year old neighbor. His 30 year old L295DT finally needed it's first repair ouside of routine maintenance. He blew a hydraulic line while using...
The tachometer on my 1980 L295DT has stopped working. The arrow on the gauge does not move when the engine is operating. I checked the connection on the back of gauge and it appears to be secure...
Last spring my son in Utah bought a Kubota L295DT, with attachments. He is the second owner. I've been looking around for him for a source for a ROPS. I did find one company that can provide a...
I've got an early 80's Kubota L295DT tractor with Low Compression, I've had two different dealers tell me you could not get a rebuild kit, each part would have to be bought seperately...just...
I am working on a L295DT front end loader. I understand that the loader is not a kubota product but the name plate is gone. Is there anyone that knows the brand of the loader I might have and...
I'm looking at buying this tractor. Its runs good. Looks like ****.
FEL has alots of re-welded areas.
What should I look for with one of these? Advise?
$6,000.00 purchase price.
Hi,
I have a Kubota L295DT with an after-market front end loader. I believe the tractor and loader are late 1970's vintage, and have learned that the loaders were typically after-market add-ons...
Any info you can give me about the L295DT. I found one for what I think is a good price $4800. Is that a good price? Is this a good machine aside from the fact that its a Kubota :D How much does...
Loader Control Valve Replacement \'79 Kubota L295DT
I have isolated the reason for my loader bucket slowly drooping. The Control Valve. Although the lift valve is fine, the curl valve is leaking...
For owners of L295DT tractors - is the long tie rod between the wheels supposed to be straight? Mine has a slight upward bend to it. Thanks for checking.
I've just bought above tractor (sight unseen) and owner has advised "runs but motor fumes & water pump leaks". Anyone out there know of possible/probable cause symptomatic of fuming issue and a...
I just bought a Kubota L295DT about 3 hours ago. It has a few small issues to address that won't be too difficult to fix, but there is one that has me puzzled. The 3 point raises and lowers OK...
I lost reverse on the L295 that I use and upon removing the gear shift lever assembly/cover I found the forked gear moving arm was broken for the reverse. I replaced it but then ran into the...
I have a L295DT with a Kubota loader 1200HD and a cab. Need to remove loader to do some engine repair, can this loader and cab be removed in one piece, or does it need to be dismantled? I have a...