Mounting tire chains

[ovrszd]

That fist worth of slack is what's recommended for the Euro-style chains (like the Ofa EKO chains). For Ladder-style chains, tensioners are recommended. If I recall correctly, tensioners are recommended for DuoGrip style chains as well.

I've ran 2-link ladder style chains thousands of miles at 15mpj without tensioners with no problems. I see no way an elastic tensioner is of any value unless it's strong enough to require some form of mechanical installation tool to stretch it.

 

[Garandman]

We have Ofa Eco 8 chains on rear. The slack is a little more than the fist width recommended. We put one bungee on the inside, one on the outside and it snugs them up just enough.

Very icy around here right now so it was a good move.

 

[John_Mc]

I've ran 2-link ladder style chains thousands of miles at 15mpj without tensioners with no problems. I see no way an elastic tensioner is of any value unless it's strong enough to require some form of mechanical installation tool to stretch it.

I ran a tensioner on my ladder style chains the first season I used then, then never put them on again. (Basically, even with a special installation tool, I judged that getting them on was more hassle than I was willing to put up with.) I'm not saying they won't work without tensioners, I'm just relaying what two different chain vendors said, as well as my tractor dealer about running ladder style chains: Using a tensioner gives the best life on the chains and on your tires. I did not ask why.

When I switched to my Ofa EKO chains Those same vendors also said not to use tensioners on them (or the similar Euro-style chains one of the vendors was selling).

 

[Garandman]

So what did the Ofa Eco vendors say when the chains were looser than recommended, after removing all the extra links? Because that’s where I am.

 

[John_Mc]

So what did the Ofa Eco vendors say when the chains were looser than recommended, after removing all the extra links? Because that痴 where I am.

I think I may have answered this in a different thread. I'll see if I can find it. If I recall, you and I have the same size rear tires: 15-19.5

[EDIT] Here is the link to my post in the L3301 snow chains thread in the Kubota forum. I assume you've seen it by now, but it may be of interest to others faced with the same issue with the Ofa EKO chains.

 

[Garandman]

We found some twisted links, and shackles attached to the wrong link. If you are not paying attention when you fasten the twist links, the chain twists. When we untwisted it there was enough slack to get rid of an extra link.

Once fixed, seems to be working properly without any tensioners.

 

[MarblemountLane]

All this reminds me that I am headed over to the other place today, to adjust the tensioners on the new chains I bought for my MF 204. I have some work to do in the brush, and I will just leave them on, even though we have no snow at the moment.

As to clipping the end of the chains onto the tire then driving forward one revolution, I believe Campbell included a clip for that with every set of car chains, back in the days before radial tires, when all of our chains looked like ladders.

One of my bad memories is getting a 1955 GMC fuel delivery tanker stuck in mud, THEN having to chain up with dual tire chains on 9:00-20 lug tires inside those close fitted tanker fenders. On ice, chains do not have to be big, but constant contact is desirable, as opposed to the slip-grab-slip of ladder style chains with few cross chains. In mud, one wants large chains, not necessarily tight on the tires.

 

[John_Mc]

"My happiest experience is to mount the chains and then never have enough snow that season to get in it. " I'll second that!

My happiest experience used to be putting off installing my chains for as long as I could, then making it through the winter without installing them at all. Since I switched to the "drive them on" method, It's no big deal. The only unhappy experience is when I put off installing them for too long, and then end up installing them at night, in the middle of a blizzard when it's 10˚F outside.

 

[fruitcakesa]

My happiest experience used to be putting off installing my chains for as long as I could, then making it through the winter without installing them at all. Since I switched to the "drive them on" method, It's no big deal. The only unhappy experience is when I put off installing them for too long, and then end up installing them at night, in the middle of a blizzard when it's 10˚F outside.

I did that only once:

 

[jmc]

I did that only once:

I've finally learned to replace a sluggish battery in October rather than a dead one in January.