My Garage/Shop Heater Install

   / My Garage/Shop Heater Install #201  
Hmmm, dinner; good plan :=)
Later... Steve
 
   / My Garage/Shop Heater Install #203  
Says "invalid attachment"...
 
   / My Garage/Shop Heater Install
  • Thread Starter
#204  
IMG_4057.jpg
 
   / My Garage/Shop Heater Install #205  
Did you check all connections , and is the unit properly grounded.......
 
   / My Garage/Shop Heater Install #207  
Does the un-insulated part of the flame rod continue thru a hole in the burner, and if so how much clearance is there between that hole and the rod?
 
   / My Garage/Shop Heater Install
  • Thread Starter
#208  
Does the un-insulated part of the flame rod continue thru a hole in the burner, and if so how much clearance is there between that hole and the rod?
I just can't tell. It disappears behind the box on the left and I cannot get my hand around it. Or the iPhone camera to 'see' through the hole in the bulkhead that the probes are mounted to. I need a fancy little mirror on a stick but that is where the action is. Are you wondering if it is shorting to ground? I would think I wouldn't get combustion if this was the case.
 
   / My Garage/Shop Heater Install #209  
Kill power, remove the spade from the flame rod, measure the rod to ground. Should be a few "gigaOhms" (OPEN)

Flame rod supposedly goes straight to control board (see page 18, lower left corner of the board)
 
   / My Garage/Shop Heater Install #210  
Sooo, we done for the night or did you decide 9mm test gear wuz more fun? :D ... Steve
 

Tractor & Equipment Auctions

2017 Yale GLC050VX 3,500 lb LPG Forklift - Powershift, Aux Hydraulics (A55302)
2017 Yale GLC050VX...
2021 Ver-Mac PCMS-3812 Solar S/A Towable Trailer Message Board (A55973)
2021 Ver-Mac...
2018 KENWORTH T800 DAYCAB (A55745)
2018 KENWORTH T800...
1R SILT FENCE PLOW (A52706)
1R SILT FENCE PLOW...
2001 CATERPILLAR IT28G (A52472)
2001 CATERPILLAR...
Komatsu WA180-1 Wheel Loader (A47477)
Komatsu WA180-1...
 
Top