tooth bar . again?

impdaddy · Sep 14, 2009

thinking about adding a toothbar to my 110 tl loader on a NH 1520. Any idea what these cost? I know many ppl have talked about the Markham bars. any others anyone recommend? I would want a bolt on.

Thanks to all the good TBN members.

Sideways · Sep 14, 2009

Check E-bay.
I bought one a couple of months ago, reasonably priced with shipping.

kennyd · Sep 14, 2009

Figure around $300 to your door...Give Mellisa a call

papavillars · Sep 15, 2009

okay who is melissa, I am new to this forum..thanks

kennyd · Sep 15, 2009

papavillars said:
okay who is melissa, I am new to this forum..thanks

Welcome to TBN

Mellisa is the co-owner of Markham Welding

papavillars · Sep 15, 2009

thanks kennyd for the answer. I also need one

ninefinger · Sep 15, 2009

The mounting bars, at least from Markham, have elongated holes. When you drill the holes in your bucket drill to the teeth side of the hole, by doing this you can loosen the bolts, pull the toothbar foward and flip it back in the bucket and not have to completely remove it.

RalphVa · Sep 16, 2009

For the Markham, you'll need to drill 2 holes in the sides of the FEL to attach it with big bolts. Think mine are about 5/8". Wait until you get it. Should be some instructions about where to drill, etc. I had the dealer install mine before I took the tractor home.

If you don't have the proper drill, bit, etc. you can likely just take the bucket itself off in the bed of a pickup and take it to the dealer.

Ralph